• Set of 40 replacement electrode pads

• Universal 3.8mm stud or snap connector

• Compatible with most TENS and EMS units

• Resealable pouch with a protective liner

• FABRIC BACKING

 

 

FEATURES

SAFE REPLACEMENT PADS

Continue pain-relieving treatments with FDA-approved replacement electrode pads

 

UNIVERSAL COMPATIBILITY

Pigtail 2mm stud or snap connector is compatible with most TENS, EMS and muscle stimulation devices

 

PREGELLED AND SELF ADHESIVE

Pregelled with a conductive hydrogel, the pads easily secure to the skin without leaving a sticky residue following each treatment

 

FLEXIBLE SQUARE PADS

Square electrode pads are constructed with a non-woven cloth backing that is flexible for optimal placement

 

LATEX FREE

Latex-free and PVC-free, the non-irritating electrode pads are safe for all skin types

 

REUSABLE 10 SETS OF 4

Each set of four includes a protective liner in the resealable pouch for safe storage

What’s Included:

- 40 Replacement electrode pads with FABRIC backing, 10 sets of 4 

- Lead connectors

- 60 day guarantee

 

Uses: Replacement electrode pads for TENS, EMS, and muscle stimulation devices

Dimensions: 1.97” by 1.97”

Materials: Non-woven cloth backing. Conductive carbon film (Low impedance), Conductive hydro gel, Lead wire with 2mm DIN size or snap connector

 

How To Use: Read the device user manual thoroughly before use. Skin must always be clean, dry and free from lotion or powders. Attach lead wires to electrodes before applying to skin. Remove the protective backing from the electrode. Save for future use. Apply the electrode to the skin, center first, then smooth down the edges. Attached are the lead wires to the device and turn it on. Adjust the settings according to the treatment plan. Do not exceed the intensity of .1 Watt/cm2. When treatment is complete, turn the device off. Lift the electrode at the edges and peel to remove it from the skin.

 

Care Instructions: Replace the saved backing on the sticky side of the electrode. Disconnect the device from the lead wires and electrode. Store the electrode in the original packaging. Keep electrodes away from direct sunlight. If the electrode loses adhesion properties, gently rub one or two drops of water onto the gel surface to reactivate the adhesion. If that does not work, discard the electrode. Discard the electrode in the original packaging after 20-25 uses.